Pd/activated carbon sorbents for mid-temperature capture of mercury from coal-derived fuel gas

Higher concentrations of Hg can be emitted from coal pyrolysis or gasification than from coal combustion, especially elemental Hg. Highly efficient Hg removal technology from coal-derived fuel gas is thus of great importance. Based on the very excellent Hg removal ability of Pd and the high adsorption abilities of activated carbon（AC） for H2 S and Hg, a series of Pd/AC sorbents was prepared by using pore volume impregnation, and their performance in capturing Hg and H2 S from coal-derived fuel gas was investigated using a laboratory-scale fixed-bed reactor. The effects of loading amount, reaction temperature and reaction atmosphere on Hg removal from coal-derived fuel gas were studied. The sorbents were characterized by N2 adsorption, X-ray diffraction（XRD） and X-ray photoelectron spectroscopy（XPS）. The results indicated that the efficiency of Hg removal increased with the increasing of Pd loading amount, but the effective utilization rate of the active component Pd decreased significantly at the same time. High temperature had a negative influence on the Hg removal. The efficiency of Hg removal in the N2-H2S-H2-CO-Hg atmosphere（simulated coal gas） was higher than that in N2-H2S-Hg and N2-Hg atmospheres, which showed that H2 and CO, with their reducing capacity, could benefit promote the removal of Hg. The XPS results suggested that there were two different ways of capturing Hg over sorbents in N2-H2S-Hg and N2-Hg atmospheres.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

基于DMSP/OLS数据的江苏省城镇人口空间分异研究

人口空间分异研究是区域协调发展的基础,便捷准确地获取城镇人口全局和局域的空间信息,对于合理制定区域人口、经济和社会发展政策具有重要意义。在DMSP/OLS(夜间灯光)数据和人口数据之间的定量关联基础上,模拟出格网尺度上江苏省2012年人口密度,采用人口集中指数、空间变差函数识别人口分布的空间格局并探讨区别于行政单元尺度的人口格局形成机理。区域层面,江苏省人口空间分异呈现苏北地区"低密度点状"分布,苏南、苏中为"高密度面状"分布并存格局。城镇层面,江苏省人口空间分布结构具有4种类型,H-H型地区人口各向差异性最强,网格单元内随机变异最小;H-L型人口各向差异性最小,网格单元内随机变异较大;L-L型人口轴向均质化特征明显,网格单元随机变异较小;L-H型空间各向差异性较小,网格单元的随机变异最大。结果表明,基于DMSP/OLS夜间灯光数据反演而得到的人口格网模型具有巨大潜力,结合变差函数进行拟合分析可定量地刻画城镇内部人口分布的空间异质性特征。     

CdSe/ZnS量子点对稀有鮈鲫胚胎发育的影响及其氧化应激作用

本研究以稀有鮈鲫(Gobiocypris rarus)为对象,研究了不同浓度CdSe/ZnS量子点(QDs)暴露下,稀有鮈鲫胚胎发育过程中自主运动频率、内心率和体长的变化,以及利用体内超氧化物歧化酶(SOD)和丙二醛(MDA)作为毒性指标,反映CdSe/ZnS QDs暴露对稀有鮈鲫胚胎发育的氧化应激作用.结果显示:CdSe/ZnS QDs对稀有鮈鲫胚胎72 hpf(hours post fertilization)的半致死浓度(LC50)为319.629 nmol·L-1,96 hpf的半致畸浓度(EC50)为203.312 nmol·L-1.CdSe/ZnS QDs暴露不仅影响稀有鮈鲫胚胎死亡率、畸形率、自主运动频率、孵化时间和孵化率,而且使其内心率减缓、体长缩短,导致胚胎卵凝结,心包囊肿,出现脊椎弯曲等多种毒性现象.同时发现,CdSe/ZnS QDs暴露导致稀有鮈鲫体内MDA含量增加以及SOD活力的降低.这表明CdSe/ZnS QDs对稀有鮈鲫胚胎发育具有致畸、致死作用,而氧化应激可能是引起其胚胎致畸、致死的重要机制之一.     

多段A/O工艺处理制革废水一级生化出水的效能

针对现有制革废水处理工艺难以使氨氮达标排放的问题,引入多段A/O工艺(MAOP)作为制革废水二级生物处理单元,探讨分段进水、水力停留时间(HRT)以及污泥回流比(R)对其COD和氨氮同步去除的影响.结果证明,无论是否分段进水,四段MAOP对制革废水一级生化出水均有良好的COD去除效果,当污泥停留时间(SRT)为18d、HRT不小于24h时,其出水浓度都可保持在300mg/L以下,满足GB8978-1996二级排放标准.在各段进水比为4:3:2:1、R 100%、HRT 48h、SRT 18d条件下,MAOP对制革废水一级生化出水的氨氮去除率高达97.7%,出水浓度3.6mg/L左右,达到GB8978-1996一级排放标准.MAOP同时具备反硝化、短程硝化反硝化、同步硝化反硝化等多种脱氮机制,是一种颇具前景的制革废水生物脱氮技术.     

中国危险废物和医疗废物焚烧处置行业二（口恶）排放水平研究

通过调研全国危险废物和医疗废物焚烧处置设施,对包含二噁英排放水平的设施按处置对象、炉型和处理量分类,并作系统分析和研究.结果表明现有危险废物焚烧设施烟气中二噁英的浓度比医疗废物低,达标率为74.19%;危险废物选用回转窑处置效果较好,达标率为66.67%;而医疗废物选用回转窑或热解炉,要综合考虑处置规模、生产成本和二英排放总量等因素;危险废物介于10~30 t·d-1和医疗废物介于10~20 t·d-1的处置设施要尤其注意二噁英的排放问题;医疗废物焚烧飞灰中二噁英的均值浓度为危险废物6倍以上,仅有16.67%满足填埋要求.二者烟气中二英的浓度分布以1,2,3,4,6,7,8-HpCDF、2,3,7,8-TCDF和OCDD为主.     

聚醚砜超滤膜接枝聚乙烯醇-氨基酸共聚物的亲水改性研究

基于聚合多巴胺的附着性及易与氨基(—NH2)等基团形成共价键的特性,本实验将聚合多巴胺作为对聚醚砜(PES)超滤膜进行表面改性的接枝中间物,将聚乙烯醇(PVA)-氨基酸共聚物接枝至PES膜表面,从而提高PES超滤膜的亲水性能.实验通过PVA与氨基酸的酯化反应形成PVA-氨基酸共聚物,将带有—NH2的共聚物与PES超滤膜表面的聚合多巴胺涂覆层形成共价键,从而将亲水的PVA-氨基酸共聚物接枝到疏水的超滤膜表面.实验利用通量的变化、红外光谱(FTIR)分析、表面接触角、场发射扫描电镜(FESEM)等手段来表征膜特征参数的变化,同时也考察了改性膜对油水乳化液的分离效率和抗污染能力.试验结果表明,经过PVA-氨基酸共聚物接枝改性的膜表面的亲水性有一定的提高,原膜接触角为91°,涂覆和接枝改性后的膜表面接触角分别为71°和53°,油水乳化液的分离实验显示,改性后的膜通量和清洗恢复率均有明显提高.     

负载型Mn-Co/TiO2催化剂的制备及其低温NH3选择催化还原NO

采用浸渍法制备了一系列以成型TiO2为载体的Mn-Co/TiO2低温SCR催化剂,研究分析了活性组分担载量、Mn含量、焙烧温度、焙烧时间等制备参数和进口NO浓度、空速、O2体积分数、NH3/N2摩尔比等操作条件对催化剂脱硝反应活性的影响.结果表明:活性组分担载量为30%,Mn/(Mn+Co)摩尔比为80%,在500℃下焙烧6 h得到的Mn-Co/TiO2催化剂具有较高的NO转化率;在进口NO浓度为600×10-6、O2体积分数6%、空速10000 h-1、150℃条件下,NO脱除率接近100%.     

固相微萃取-气质联用法测定水中痕量土臭素和二甲基异崁醇

采用固相微萃-气相色谱/质谱法(SPME-GC/MS)对GSM和2-MIB进行富集检测。实验对萃取富集和仪器条件进行了优化,得出最佳实验条件：NaCl投加量30%,萃取温度65℃,萃取时间40 min,解吸3 min,不分流进样,SIM模式采集数据。实验还对萃取头的使用次数和维护进行了探讨。利用已经建立的SPME-GC/MS法对佛山市28家水厂的出厂水和原水、佛山典型景观千灯湖和亚艺公园湖水进行普查。该法具有操作简单快速、能实现自动化连续检测、准确、灵敏度高等特点,适用于饮用水中嗅味物质定性和定量。     

钛负载纳米Pd粒子电极的电化学催化性能研究

采用电化学沉积法将纳米钯粒子负载在钛板上,制备钛负载纳米钯粒子的NanoPd/Ti电极.利用循环伏安法和线性扫描伏安法对比研究NanoPd/Ti电极与Ti电极的电化学性能,以及分别对氯苯和硝基苯模拟废水电化学催化性能,表明NanoPd/Ti电极循环伏安过程出现新的氧化峰和还原峰,反应电位明显正移,反应过程峰电流也明显增大.通过降解实验,NanoPd/Ti电极可以在更低电压,更短时间内达到更好CODcr去除效果.